November 18, 2026
Shimizu Corporation(President: Tatsuya Shimmura)has successfully fabricated a one-piece, 1-meter-class rocket propellant tank using metal 3D printing technology. The fabricated tank is among the largest rocket propellant tanks produced by metal 3D printing in Japan. Performance testing also confirmed a burst pressure of up to 1.7 MPa through an internal pressure burst test. The tank was fabricated using a large-scale hybrid additive manufacturing system that combines two robotic-arm systems: a deposition robot that builds the structure layer by layer by melting metal wire, and a machining and measurement robot that monitors the build geometry and machines defective areas on the deposited surface when necessary.
In recent years, demand for rocket launches has increased significantly, driving technological development worldwide to reduce the cost of space transportation. Metal 3D printing has attracted considerable global attention, particularly manufacturing rocket components and tank structures that require both high strength and lightweight performance.
The large-scale hybrid additive manufacturing system employed in this fabrication was developed as part of a joint research program between Shimizu Corporation and the Japan Aerospace Exploration Agency (JAXA). The joint research, initiated in 2022, focuses on the development of manufacturing technologies for rocket propellant tanks using metal additive manufacturing. During fabrication, a laser profiler mounted on the machining robot continuously monitors the geometry of the build in real time. The measured data are utilized in a feedback control system to optimize subsequent deposition paths and layer heights. When shape deviations are detected, deposition is temporarily halted, defective areas are corrected using the machining robot, and the process is then resumed.
Following the joint research with JAXA, Shimizu Corporation has been conducting research and development on large liquid propellant tanks for rockets since 2024 as part of the Space Strategy Fund, a funding program established under the Japanese government's Basic Plan on Space Policy. Going forward, the company will further enhance its manufacturing processes using the shape measurement data and pressure test results obtained from the fabrication of the 1-meter-class tank structure. By fiscal year 2028, Shimizu aims to realize the integrated fabrication of 2.5-meter-class tanks suitable for small and medium-lift launch vehicles.
≪For Reference≫
Demonstration of Metal Additive Manufacturing
The information contained in this news release is the current information on the date of publication. Please be aware that this information may have changed by the time you view it. Please contact the company to inquire for further details.